11
CONNECTING TO HOT/COLD WATER
SUPPLY
(Only in some models)
If your appliance has connections for both hot
and cold water, then connect one hose to the cold
water connection and the other hose to the hot
water connection, as indicated on the back of the
appliance:
COLD = cold and HOT = hot.
Hot water is supplied for programs operating at 40
°C or more.
Connecting to both hot and cold water will save
time and electric energy when washing.
If your washing machine model has connections
for both hot and cold water, and you only wish to
connect cold water, then the protective cap has to be
(or remain) attached to toe hot water connection.
INSTALLING THE DRAIN HOSE
Upon delivery, the appliance has a drain hose
attached. This drain hose must be connected to
a drain. Drain hose can also be attached to a wall
drain with a trap; such trap should be properly
installed to allow cleaning. The height of the drain
should be 600–900 mm above the
fl
oor. The lower
position (600 mm) is always recommended. Make
sure the drain hose is not clipped or bent.
600 - 900 mm
600 - 900 mm
600 - 900 mm
B
C
A
Drain hose can also be connected directly to the
washbasin drain via a siphon. In this case, the hose,
too, should be 600–900 mm above the
fl
oor. Internal
hose diameter should be at least 18 mm.
See
fi
gure.
At least 18 mm
