21
CLSV: (Colloidal Silver)
Much has been written about Colloidal Silver and it’s benefits. This is an important part of Bob
Becks’ suggested protocol.
Colloidal Silver (Fig 26) has fixed 27V output single polar (centre pin +) voltage and timer can
be selected from 5 to 60 minutes. No features can be adjusted during running.
Fig 26
Colloidal Silver water is very susceptible to light and temperature change, so it must be kept in
dark amber bottles or opaque containers. A stable room temperature environment is ideal. Do
NOT use plastic bottles (this will neutralize the colloids).
The silver rods supplied are 99.99% pure silver. A higher grade of silver of 99.99% purity can
be used. Lower grade silver or sterling silver will contain nickel which is toxic and must NOT
be used.
Connect the silver rods to the alligator clips; plug this lead to the
“output” (4)
on the main
device. Place the silver rods over the top lip of the glass (see picture below).
Use 250ml distilled water. Place the silver rods 4-5cm apart. Keep them parallel and do not let
them touch (otherwise it is likely to “short” the unit out and render it ineffective).
One rod will emit bubbles, the other, a grey mist. Generate for 5-30 minutes.
ONLY USE DISTILLED WATER!
Switch unit on (8) and scroll up or down to CLSV, press SELECT (5)
Select desired time, scroll up or down and press SELECT (5) to confirm timer.
The unit is operating and generating Colloidal Silver water.
The unit will switch off after the cycle has finished.
