24
TENS: (Transcutaneous Electrical Nerve Stimulation)
TENS (Fig 29) has two sub programs: P_1 and P_2.
Fig 29
P-1
: Dual polarity pulse output in 100Hz frequency. Pulse width changes from 200us to
100us in every 3 seconds cycle on 6 steps. 200-184-167-150-134-117-100us and repeat.
P-2
: Dual polarity pulse output in 100Hz and 2Hz. Pulse width changes from 200 us to
100 us in about every 6 seconds cycle. Two frequencies changed over when current cycle
finished.
Fig 30
Setup:
Turn power on, press up/down buttons untill “TENS” is selected, press SELECT (5) to con-
firm. Then select program “P_1” or “P_2” by press UP (7) / DOWN (6). To confirm by press
SELECT (5), then press UP (7) / DOWN (6) to select timer from 5 ~ 60 minutes. After timer
select, press SELECT (5) to start the program. The unit will automatically switch off after set
program has finished.
T.E.N.S. Pads:
Please note:
Before placing adhesive pads, make sure the skin is clean and free from dirt or grease.
Place in the positions shown above.
Please note the pads can be reused.
