MPS-Series – Configuration Guide
U-0664-0265.doc – Issue: 03 complete, approved
Page 32 of 60
Configure a button for ‘MIC Routing’, and then select the output or group of outputs to which audio
(microphone) is to be routed when the Zone Select button is pressed.
Consult the system design documentation for which outputs are used for which audio zones. Note that
to simplify this process the Router may have had the output names changed to zone names.
4.6.3
DVA Routing Button (VAR4/VAR12/VAR20 only)
Menu:
Configuration
Æ
System
Æ
Router
Æ
Inputs
Æ
Mic/Line
Æ
<
I/P #
n
–
name
>
Æ
Paging Microphone
>
Æ
Buttons
Æ
Zoning
Æ
<
Button
#
nn
>
Æ
DVA Routing
The ‘DVA Routing’ button function enables simple control of a single broadcast route, or complex broadcasts
to be set up. For instance when a button is pressed a route can be made that connects any desired
combination of audio inputs to any combination of outputs. Audio inputs are typically DVAs. However, other
types of inputs such as microphone and background music can also be routed.
An example of this is a button programmed to cause an EVACUATE message to be broadcast in one zone,
and simultaneously cause an ALERT message to be broadcast to adjacent zones, while all remaining zones
are unaffected.
Another example would be a set of ‘DVA Routing’ buttons which controls background music broadcast to
selected zones in the system.
Note that ‘DVA Routing’ is not supported on inputs 3,4 and 11 to 20.
Configure a button for ‘DVA Routing’, and then configure the following parameters.
4.6.3.1
Controlled Route or Routes
Menu:
Configuration
Æ
System
Æ
Router
Æ
Inputs
Æ
Mic/Line
Æ
<
I/P #
n
–
name
>
Æ
Paging Microphone
>
Æ
Buttons
Æ
Zoning
Æ
<
Button
#
nn
>
Æ
DVA Routing
Æ
Zoning
Configure the route or routes that it controls, by associating an input to each available output.
Consult the system design documentation for which outputs are used for which audio zones. Note that
to simplify this process the Router may have had the output names changed to zone names.
4.6.3.2 Trigger
Mode
Refer to Section “4.6.8.1 Trigger Mode” (page 35).
4.6.3.3
DVA Play Mode
Refer to Section “4.6.8.2 DVA Play Mode” (page 36).
4.6.3.4
Busy Indication Mode
Refer to Section “4.6.8.3 Busy Indication Mode” (page 36).
Summary of Contents for MPS Series
Page 60: ......