Asoka® User Guide
PlugLink PL7667-ETH
Page 13 of 33
Chapter 4
Installation
This chapter describes how to install your CPE device and how to interpret the LEDs to ensure
proper operation. Read the topics, and perform the procedures in the following order:
Preparing for Installation
Warnings
Safety Instructions
Installing the CPE
Connecting to a 10/100 Port
Wall mounting the CPE
Preparing for Installation
If you mount the CPE to a power outlet, use the screws supplied with the
CPE.
There are no serviceable parts inside the unit. Removing the screws,
cover, or otherwise dismantling the unit voids the warranty.
Warnings
Only trained and qualified personnel should be allowed to install or replace this equipment.
Read the installation instructions before you connect the system to its power source.
Before working on the equipment that is connected to power lines, remove all jewelry
(including rings, necklaces, and watches). Metal objects will heat up when connected to
power and ground and can cause serious burns or weld the metal object to the terminals.
The plug-socket combination must be accessible at all times because it serves as the main
disconnecting device.
To prevent the system from overheating, do not operate it in an area that exceeds the
maximum recommended ambient temperature of 104ºF (40ªC).
