Asoka® User Guide
PlugLink PL7667-ETH
Page 14 of 33
This product relies on the building’s installation for short-circuit (over current) protection.
Ensure that a fuse or circuit breaker no larger than 120 VAC, 15A U.S. (240 VAC, 10A
International) is used on the phase conductors (all current-carrying conductors).
A voltage mismatch can cause equipment damage and may pose a fire hazard. If the
voltage indicated on the label is different from the power outlet voltage, do not connect the
device to that receptacle.
Do not work on the system or connect or disconnect cables during periods of lightning
activity.
Ultimate disposal of this product should be handled according to all national laws and
regulations.
Safety Instructions
Read these safety instructions carefully.
Read all cautions and warnings on the equipment.
Plug this equipment directly into a power outlet. No power strips and no extension cords.
Make sure the equipment is connected to the right voltage.
For pluggable equipment, the socket-outlet must be installed near the equipment and must
be accessible.
Place the Ethernet cord where people cannot step on it. Do not place anything over the
Ethernet cord.
Disconnect this equipment from the power outlet before cleaning it. Do not use liquid or
sprayed detergent for cleaning. Use moisture sheet or cloth for cleaning.
Keep this equipment from excessive humidity.
The openings on the enclosure are for air convection and protect the equipment from
overheating. Do not cover the openings.
If the equipment will not be used for a long period of time, disconnect the equipment from
the power outlet to avoid any damage from transient over-voltage.
Do not pour any liquid into opening. This could cause fire or electrical shock.
Do not open the equipment casing. For safety reasons, the equipment should only be
opened by qualified service personnel.
Have the equipment checked by a service professional if one of the following situations
arises:
•
The plug is damaged.
•
Liquid has entered the equipment.
•
The equipment has been exposed to moisture.
•
The equipment does not work properly, or you cannot get it to work according to
user’s manual.
•
The equipment has been dropped or damaged.
•
The equipment has obvious signs of breakage.
•
Do not leave this equipment in an unconditioned environment. Temperatures above
45ªC (113ªF) can damage the equipment.
•
Keep this guide for later reference.
Installing the CPE
