Asoka® User’s Guide
PlugLink® 9850 IP Camera PL9850-CMS
11
Chapter 4
Connecting the PlugLink 9850 IP Camera for Setup
Before connecting your PlugLink 9850 to your wired network, please connect it directly
to your computer with an Ethernet cable.
Connection to a Wired Network for Setup
1.
Connect the power supply into a nearby wall outlet.
2.
Connect the enclosed Ethernet cable to the Ethernet port of the unit.
3.
Connect the other end of the Ethernet cable to the Ethernet port of the PC.
4.
Turn on PC.
The camera’s LED flashes while the camera is initializing. The camera is ready for
use when the LED is lit and stops flashing.
If you need to move the camera from a wired network to a power line network,
please reference the section below: “
Moving the Camera to a Power Line Network
.”
If you do not require changing your network type, proceed directly to “
Chapter 5:
Installing and Configuring the PlugLink 9850 IP Camera”
.
Moving the Camera to a Power Line Network
When you move the Camera from a wired network to a power line network, or vice
versa, you must power off the camera before connecting to the new network.
To move the camera from a wired network to a power line network, follow these
instructions:
1.
Unplug the power adapter from the camera.
2.
Unplug the Ethernet network cable from the camera.
3.
Re-connect the power adapter to the power port on the camera.
The camera’s LED flashes while the camera is initializing. The camera is ready for use
when the LED is lit and stops flashing.
