FXSO H.323 Gateway User Manual
Document Ver.: 105
Release Dec, 2004
102
5.
You will get another dial tone from the PSTN line which was connected
with the Line 1 port.
6.
Answer the call and make sure the call is connected.
7.
Hang up the phone which is from the Line 2 port and you will get the
disconnect tone from the Line 1 port.
8.
When you get the disconnect tone from the Line 2 port, press <
R
> and
<
ENTER
> buttons to start recording the disconnect tone.
9.
Please hang up the phone if you get the message as below
：
Analizing!!
Please wait a moment…
10. There are three values you will get after analyzing. Please leave the value
which is over 1000 Hz, this is not the frequency of disconnect tone.
11. Please put the frequency in the tone table just follow the command
：
tone 4 420 680 8 8 25 25 50 50
【
Example -1
】
(Make a call from PSTN toFXSO port)
usr/config$ record -tone
Press (R) to start record...
(Please make sure that you are already finish the steps 2 ~ 7)
r (Press “Enter” button after you key in “R”)
....................................................................................................
....................................................................................................
....................................................................................................
............
Analizing!! Please wait a moment...
(You coule hang up the call from PSTN if you get this message)
Frequency 1 : 481
Frequency 3 : 621
0.25sec on 0.25sec off
tone 4 481 621 8 8 25 25 1023 1023
(Put this value in to the tone table)
