FXSO H.323 Gateway User Manual
Document Ver.: 105
Release Dec, 2004
29
u
DNS primary – To configure the first ip address for the DNS server.
u
DNS secondary – To configure the second ip address for the DNS server.
u
HTTP Port – To configure the HTTP port for access this unit from the
remote side.
u
SNTP – Enable the SNTP server registering function if user wants to get
the correct time from the Command Line Interface.
u
SNTP Server Address – Enter the correct ip address of the SNTP server
or get the incorrect time from the Command Line Interface.
u
GMT – Configuring the time area for the time display in the Command
Line Interface.
u
IP Sharing – Enable this function if the gateway is behind the IP sharing
device.
u
IP Sharing Server Address – Enter the WAN IP address of the IP sharing
device if it is the fixed ip.
u
IP Change – Enable this function if the WAN IP address of the IP sharing
device is dynamic address.
u
PPPoE User Name – To configure the user name for the PPPoE
connection.
u
PPPoE Password – To configure the password for the PPPoE connection.
u
PPPoE IP Address – In the PPPoE mode, this table will show the ip
address that this unit gets from the ISP.
u
PPPoE Destination – In the PPPoE mode, this table will show the default
gateway address that this unit gets from the ISP.
u
PPPoE DNS primary – In the PPPoE mode, this table will show the DNS
ip address that this unit gets from the ISP.
u
After Remote Host Disconnection – This unit will reboot and re-connect to
the ISP
u
Send PPPoE Echo Request – In the PPPoE mode, if the network
connector or the ADSL modem was lost, after the connector and modem
connected, it will reboot automatically for the re-connect with the PPPoE
server.
u
EMS Configuration
The IP change function could support the GK from us only. Please pay
more attentions about this function if your IP sharing device is using
the dynamic IP address.
