FXSO H.323 Gateway User Manual
Document Ver.: 105
Release Dec, 2004
79
gateway has incoming call 1001, after drop gateway prefix
100, it will search line number “1”. So line number must be
set as “1”.
-eod
It will transfer the DTMF in “#” if users disable the end of dial
function. Users have to press the key pad in “#” if the end of
dial function is enable.
-silence The call will be dropped if theFXSO detect the silence for 40
sec from the PSTN side.
-ring
ring time for ring detection(in ms). When Gateway has
incoming call from PSTN side toFXSO port, Gateway will
determine it is a ring but not noise only if it is longer than this
ring time.
Note:
In Taiwan the ring time of PSTN usually is 1000ms, so if user
set ring time longer that 1000ms,FXSO port may not be able
to pick up the call from PSTN side.
-rba
Users could define the ring time if the calls coming from the
PSTN side. This support 1 to 10 ring times.
-delay The DTMF signal will be sent for the time delay. This function
just supports the one -stage-dialing function.
-connect The unit will send the connect message to the IP side
automatically. This function just supports the
one-stage-dialing function.
-fxotype It’s for the 2nddial function. Any calls will be two-stage-dialing
if user enable this function.
4.2.11 [h323]
Phone Book function allows users to define their own numbers, which
mapping to real IP address. It is effective only in peer-to-peer mode.
When adding a record to Phone Book, users do not have to reboot the
machine, and the record will be effective immediately.
-------------------------------------------------------------------------------------------------------
usr/config$ h323
