FXSO H.323 Gateway User Manual
Document Ver.: 105
Release Dec, 2004
82
number on the Gatekeeper.
-line1
assign Line1 number.
-line2
assign Line2 number.
-line3
assign Line3 number.
-line4
assign Line4 number.
Note:
User can also set “x” in line number to disable the port. If the port is
disabled, it can only receive calls but not calling out.
Note:
1. Line1~Line4 number must follow the prefix number if device is
configured as
Gateway Type
. For example, if prefix number is 999,
then the line1 & line2’s number are 9991 & 9992.
2. If Gateway is configured as
Terminal Type
, each line will register to
GK with it’s own number, prefix number is not needed.
3. No matter in GK or P2P mode, user only needs to dial line number to
reach the local port.
For example, in P2P mode, user wants to dial from
FXS TEL1 toFXSO Line1, only need to dial number of line2.
-passwd
set H.235 security password. If user’s GK need H.235
security token password to authenticate, user have to input
topen password in this command. (please refer to your
retailer of GK for information about token password if they
implement this function in their GK)
-alias
H.323 ID. If in gatekeeper mode, this h.323 ID must be
different from others who are registering to the same
gatekeeper.
-display
An addition name for special application if the calling party
needs this to recognize the called party.
-gkid
set GateKeeper name for GateKeeper discovery. When
Gateway send out GateKeeper discovery message will
search GateKeeper with this GateKeeper name. (please refer
to -gkdis)
-gkdis
set auto discovery function on or off. If this function is enabled
and IP address of GateKeeper is set as 255.255.255.255,
