FXSO H.323 Gateway User Manual
Document Ver.: 105
Release Dec, 2004
83
LAN Phone will multicast to search a GateKeeper on network
with configured GateKeeper name (please refer to -gkid); if IP
address of GateKeeper is set, before LAN Phone register to
the assigned GateKeeper, it will send out GRQ(GateKeeper
Request) message with configured GateKeeper name to
GateKeeper first.
-ttl
to set timer for TTL(Time To Live). Gateway would send RRQ,
with keepAlive, to gatekeeper periodically according to TTL
timer.
-rtp
to allocate RTP port range— NOT RECOMMENDED. This
may be used when RTP port range conflicts with Firewall
policy. (each port of Gateway use 2 RTP ports)
-gkfind
gatekeeper finding port. Port number, which Gateway uses it
to discover a gatekeeper. Default value is 1718.
-gkras
to set default gatekeeper RAS port number. Default value,
1719, is well-known port for RAS communication.
-h225
to specify H.225 RAS port number.
-q931
to specify H.225 signal port number.
-dstq931
to specify destination H.225 signal port number.
-range
To allocate port range (1500-65535) Gateway may use it.
-respto
Maximum response time out
-connto
Maximum connection time out
Note: From –rtp to –conneto commands are for advanced users, please
do not change the default settings if not necessary.
4.2.12 [line]
This command is for configure each line parameters of Gateway.
-------------------------------------------------------------------------------------------------
usr/config$ line
Gateway line information and configuration
Usage:
line [-print][-config number [hunt number][hotline number]
line -print Gateway line information.
-config Set Gateway line information.
h u n t : Hunting group.
