FXSO H.323 Gateway User Manual
Document Ver.: 105
Release Dec, 2004
84
hotline: Hot line configuration.
Example:
line -config 1 hunt 1 hotline 1003
usr/config$
Parameter Usages:
print out all current settings of line
-config
determine which line to configure
-hunt
set hunting group flag of each line. User can assign different
hunt group number represent different hunt group. For
example, if user assigns FXS TEL1 as hunt group 1, and FXS
TEL2 as hunt group 2, they will be determined as 2 different
groups. On the other hand, if user assigns FXS TEL1 as hunt
group 1, and FXS TEL2 as hunt group 1 too, when having
incoming call to FXS TEL1, which is busy, this call will be
route to FXS Line2.
Note:
FXSO Lines and FXS TELs are treated as 2 different
groups, so even they are in the same hunt group, call will only
be routed to the same FXS orFXSO Lines.
-hotline
set hotline table.The Hotline Mode is applied in limited two
channels. User just picks up the phone set of one FXS TEL or
calls in oneFXSO line, and gateway will automatically dial out
a phone number. In the other hand, user will hear ring back
tone or dial tone immediately depended on configurations of
destination device.
Note: This function can both work in
GK or P2P mode.
GK Mode Usage:
Set gateway under gk mode.
Create a Hotline table with “
line
” command.
usr/config$ line –config 1 hotline 1001
In this example means: if user calls inFXSO Line1, gateway
will automatically dial out “1001”.
P2P Mode Usage:
