FXSO H.323 Gateway User Manual
Document Ver.: 105
Release Dec, 2004
92
support -fstart 1
support -tunnel 1
support -h245fs 1
support -earlyh245 1
usr/config$
Parameter Usages:
print current settings in
support
command.
-t38
to switch ON/OFF (1 = ON; 0 = OFF) T.38 fax ability. When
T.38 ability is ON, Gateway will automatically defer codec
(G.723 or G.729 series) to T.38 when FAX signal is
detected.
-t38rq
The T.38 could support the request mode message sending
or not. 0 for disable the request mode sending and 1 for
request mode sending with the T.38.
-t38ecm
to switch ON/OFF (1 = ON; 0 = OFF) T.38 fax Error
Correction Mode ability. When high-speed T.38 FAX is
running, Gateway will automatically execute ECM function.
-t38asn1 Enable the ASN.1 support with the FAX.
-faxrdd
set fax redundancy depth. User can increase FAX
redundancy depth when network traffic is heavy. For
example, if user set fax redundancy as 2, Gateway will
resend fax packets every 2 packets.
-fstart
to switch ON/OFF (1 = ON; 0 = OFF) fstartStart function.
Fast Start function can shorten the connection time if the
opposite party also supports fastStart.
-tunnel
to switch ON/OFF (1 = ON; 0 = OFF) H.245 tunneling
function. If the function is ON, Gateway will send H.245
(Call Control messages) via H.225’s (Call Signal messages)
link. The function is effective only when both sides support
H.245 tunnel.
-h245fs
If the function is ON, Gateway can send H.245 messages
after FastStart.
-earlyh245
enable/disable early H.245 function. The function is
effective only when both sides support early H.245.
