Dynamix DW-01Plus/H Gateway User Manual
- 51 -
-
Forward time
: It supports the No Answer Forward function. If users configure it
for 10, the call will be forwarded when it rings about 10 seconds. From 5 to
65535.
-
Keypad Type
: User could define the keypad for the DTMF sending.
1.
In-Band : The DTMF signal sending by RTP.
2.
Out-Band : The DTMF signal sending not by RTP. Including
the H.245(Alpha), H.245(Signal), Q.931 and RFC 2833.
-
User Defined Prefix Switch
: Select on/off for User defined local zone prefix
switch. If user enables prefix function, once user dials out, gateway will
automatically add prefix number before number user dialed.
-
User Defined prefix Disable
: Disable the defined prefix after press the
selected digit (0,1~9, *).
-
User Define prefix
: This will be added in the first digits of the numbers that
users had dialed. Can also define IP address here in P2P mode, once user
press
“
#
”
, Gateway will call out this IP address.
-
Codec Select Method
: This could support that the codec will follow the MSD
(MasterSlaveDetermination) or the caller side.
1.
Master:
Follow
the
result
from
the
MasterSlaveDetermination.
2.
Caller: Follow the caller side.
-
Reverse (FXS)
: Enable or disable the Reverse signal generation function.
-
Local Generate Ring Back Tone (FXS)
: To enable or disable the ring back
tone generation from the local side.
-
Round Trip
: The call will be disconnected automatically, if the network is
failed, default value is 10 seconds.
-
Gateway Prefix
: To keep or drop the prefix number of this gateway. This
only support the Gateway type in the GK routed mode. Please get more detail
useful as below:
-
End of Dial:
To enable or disable the end of dial function. This function key
will be the digit
“
#
”
.
-
Dial to PSTN side (162)
: This function can let user dial out by PSTN. User
just need to press
“
*#
”
, the call signal will relay from IP side to PSTN side.
-
Detect silence voice (FXO)
: This function could detect the silence from the
PSTN side. If the FXO detect the silence for 40 seconds continuous, it will drop
the calls.
Only support FXO
.
-
Ring Time (FXO)
: It for the ring detection from the PSTN. The ring detection
will be failed if users configure it too long.
Only support FXO
.
-
Ring Before Answer (FXO)
: This will help the users to answer the calls from
PSTN into this gateway quickly. The call will be connected by one time ring if
Summary of Contents for Dynamix DW-01Plus/H
Page 1: ...1 ...
