EN - 73
ERROR TYPE
MEANING
WHY
WHAT TO DO
E10
Fridge compartment is
not cold enough
Likely to occur after:
-Long term power failure.
-Hot food has been left in
the fridge.
1. Set the fridge temperature to
a colder value or set Super
Cool. This should remove the
error code once the required
temperature has been reached.
Keep doors closed to improve
time taken to reach the correct
temperature.
2. Please empty the location
at the front area of air duct
channel holes and avoid
putting food close to the
sensor.
If this warning continues an
authorised technician needs to be
contacted.
E11
Fridge compartment is
too cold
Various
1. Check is Super Cool mode is
activated
2. Reduce the fridge
compartment temperature
3. Check to see if vents are clear
and not clogged
If this warning continues an
authorised technician needs to be
contacted.
If you are experiencing a problem with
your
appliance
, please check the following
before contacting the after-sales service.
Your appliance is not operating
Check if:
•
There is power
•
The plug is correctly placed in the socket
•
The plug fuse or the mains fuse has
blown
•
The socket is defective. To check this,
plug another working appliance into the
same socket.
The appliance performs poorly
Check if:
•
The appliance is overloaded
•
The appliance door is closed properly
•
There is any dust on the condenser
•
There is enough space near the rear and
side walls.
Your appliance is operating noisily
Normal noises
Cracking noise occurs:
•
During automatic defrosting
•
When the appliance is cooled
or warmed (due to expansion of
appliance material).
Short cracking noise occurs:
When
the thermostat switches the compressor
on/off.
Motor noise:
Indicates the compressor
is operating normally. The compressor
may cause more noise for a short time
when it is first activated.
Bubbling noise and splash occurs:
Due to the flow of the refrigerant in the
tubes of the system.
Water flowing noise occurs:
Due
to water flowing to the evaporation
container. This noise is normal during
defrosting.
Air blowing noise occurs:
In some
models during normal operation of the
system due to the circulation of air.
The edges of the appliance in contact
with the door joint are warm
Especially during summer (warm seasons),
the surfaces in contact with the door joint
may become warmer during the operation
of the compressor, this is normal.
