8
9
6. ASSEMBLY
Aspire Evoke 2 & Evoke 2 JNR Manual Wheelchair
Box Contains:
1. Wheelchair frame fitted with 24 inch (Evoke 2)
or 20 inch (Evoke 2 JNR) rear wheels
2. Swing away legrests (pair)
3. User manual
4. Tool adjustment kit
5. Seat cushion
*Evoke 2 model shown in instructional images
When opening the carton, ensure it is done in a safe
and careful manner. DO NOT USE a box cutter or sharp
implement as this may damage the product. For OH&S
purposes, lay the carton on its side with the top of the
carton open and slide the plastic bag out containing the
wheelchair and the small carton box containing the swing
away legrests.
1. Stand the wheelchair in
an upright position on a
flat, level surface
2. Pushdown on the
side seat rails of the
wheelchair until the
seat is flat to unfold the
frame
3. Insert the legrests into
the top of the frame
receivers at a 45° angle
to the chair and swing
them in towards the
centre of the chair
until the release button
engages with a “click”
sound
1
2
3
2
3
7. PRELIMINARY CHECKS
After assembling the wheelchair, these checks should be completed prior to initial use:
1. Check that the seating surface is locked into place, creating a flat support surface
2. Check that rear wheels are locked in place and that quick release axle is not loose
3. Check that rear brakes engage and disengage
4. If fitted with accessories, ensure that they are secure and locked in place
8. GENERAL OPERATION
General Operation
It is very important that this wheelchair is used under guidance from all warnings or hazards listed in this
product user manual. Key safety measures should be taken by both users and attendants when using this
wheelchair:
• Avoid quick direction changes
• Ensure your wheelchair is used on surfaces intended for its use
• Control the speed of the wheelchair using the hand rims on the rear wheels
• Ensure an attendant is available to assist where necessary
Lifting the Wheelchair
Lift the wheelchair using the push handles and the
front upper corners of the wheelchair frame, where the
legrests are attached.
WARNING! DO NOT
lift the wheelchair by
holding it by the legrests or the armrests! Detach
the legrests prior to lifting the chair.
Transporting the Wheelchair (unoccupied)
To transport this chair in a motor vehicle it is suggested
that the legrests and rear wheels are removed to easily
fit the chair in the rear boot or backseat of a motor
vehicle.
