Ensure the direction of the brake kit is facing upwards towards the top of the wheelchair.
Remove nut
i
and washer
ii
, Slide drum brake through hole
Y
.
Stand wheelchair back onto it’s wheels (from side lying position) ensuring cable pin stays pointing towards the top
of the wheelchair.
Mount hardware
A
,
B
,
C
,
D
, through hole
X
on wheelchair and drum brake, this must be done in alphabetical
order as shown. Secure in place with 10mm Spanner & 5mm Allen key.
Mount hand brake to wheelchair handle & fasten in place with a 4mm Allen key.
Fasten wheel to wheelchair by locking in place with the quick release axle provided in the box.
Repeat steps 1 to 8 for the other side.
1300 133 120
www.aspirecare.com.au
A
S
U
M
5
8
.1
6 2
2
10
2
0
7
8
1
2
If brakes require tightening or loosening, follow below steps.
1.
Remove wheel and quick release axle from wheelchair, slide out brake cable.
2. Adjust brake strength: Tighten (Clockwise) & Loosen (Anti-Clockwise).
3. Reposition brake cable & wheel and lock into place with quick release axle.
1
2
3
7
8
9
5
6
Adjusting Brake Strength
Installing Hand Brakes
Installing Drum Brakes
3
4
LEFT SIDE
A
i
B
ii
D
CABLE PIN
C
X
iii
Y
RIGHT SIDE
A
i
B
ii
D
CABLE PIN
C
X
iii
Y
THIS WAY UP
THIS WAY UP
