ASRock Smart Remote
English
* ASRock Smart Remote is only supported by some of ASRock motherboards. Please refer to ASRock
website for the motherboard support list: http://www.asrock.com
USB 2.0 header (9-pin, blue)
CIR header (4-pin, white)
Quick Installation Guide
ASRock Smart Remote is only used for ASRock motherboard with CIR header. Please refer to
below procedures for the quick installation and usage of ASRock Smart Remote.
Step1.
Find the CIR header located next to
the USB 2.0 header on ASRock
motherboard.
Step2.
Connect the front USB cable to the
USB 2.0 header (as below, pin 1-5)
and the CIR header. Please
make sure the wire assignments and
the pin assignments are matched
correctly.
1
2
4
3
5
USB_PWR
P-
P+
GND
ATX+5VSB
IRRX
IRTX
GND
DUMMY
Step3.
Install Multi-Angle CIR Receiver to
the front USB port. If Multi-Angle CIR
Receiver cannot successfully receive
the infrared signals from MCE
Remote Controller, please try to
install it to the other front USB port.
3 CIR sensors in different angles
1.
Only one of the front USB port can support CIR function. When the CIR
function is enabled, the other port will remain USB function.
2.
Multi-Angle CIR Receiver is used for front USB only. Please do not use the
rear USB bracket to connect it on the rear panel. Multi-Angle CIR Receiver
can receive the multi-direction infrared signals (top, down and front), which
is compatible with most of the chassis on the market.
3.
The Multi-Angle CIR Receiver does not support Hot-Plug function. Please
install it before you boot the system.
