4
KEYPAD INITIATION
Keypad initiation must be done at the initial turn-on of the keypad.
1. Connect power to the keypad.
2. Put the keypad in
Program Mode
by entering “
0 0 0 0
”. The keypad will
beep twice and the yellow LED will be on and not blinking.
3. Enter “
8 9 0 1 #
”.
4. The keypad will beep twice and the keypad initiation is complete.
5. Enter “
” to exit Program Mode. The yellow LED will begin blinking.
It is strongly recommended that the
Installer Code
be changed from the default
“
0 0 0 0
”. If the
Installer Code
is not known, please refer to the section on
Direct
Access to Programming
.
1. Put the keypad in
Program Mode
by entering “
0 0 0 0
” or the current
installer code. The keypad will beep twice and the yellow LED will be on and
not blinking.
2. Enter “
0 (4 to 8 digit new installer code) #
”. For example, to change the
Installer Code
to 1 2 3 4 you would enter “
0 1 2 3 4 #
”.
3. The keypad will beep twice indicating that the new
Installer Code
has been
accepted.
4. Enter “
” to exit Program Mode. The yellow LED will begin blinking.
It is necessary to put the keypad in
Programming Mode
in order to access all
keypad configuration settings.
1. Put the keypad in
Program Mode
by entering the
Installer Code
followed by
the “
”. The keypad will beep twice and the yellow LED will be on and not
blinking.
2. Enter “
” to exit Program Mode. The yellow LED will begin blinking.
User Codes
are 4 to 8 digits long and must not be the same as the
Installer Code
.
A
User Code
can be assigned to operate either Output 1 or Output 2. The
keypad can store up to 100
User Codes
for Output 1 and up to 10
User Codes
for Output 2.
Each
User Code
has a
Code Number
. Output 1
Code Numbers
are two digits
ranging from “
00
” to “
99
”. Output 2
Code Numbers
are one digit ranging from “
0
”
to “
9
”.
1. Put the keypad in
Program Mode
by entering the
Installer Code
followed by
the “
”. The keypad will beep twice and the yellow LED will be on and not
blinking.
2. Enter “(
Output)
(Code Number) (User Code) #
”.
For example, if you wish to assign a
User Code
of “6 7 8 9” to
Code Number
“00” to operate Output 1 you would enter “
1 0 0 6 7 8 9 #
”.
If you wish to assign a
User Code
of “3 4 3 3” to
Code Number
“1” to operate
Output 2 you would enter “
2 1 3 4 3 3 #
”.
3. Enter “
” to exit Program Mode. The yellow LED will begin blinking.
ENTERING A NEW INSTALLER CODE
PROGRAMMING MODE
PROGRAMMING USER CODES
Summary of Contents for Alarm Controls KP-300
Page 12: ...KP 400 Rev E 3 14...
