Assa Abloy Alarm Controls KP-300, Operating Instructions Manual

7 

KEYPAD SILENT MODE 

The keypad beeper can be silenced. 
1.  Put the keypad in 

Program Mode

 by entering the 

Installer Code 

followed by 

the “



”. The keypad will beep twice and the yellow LED will be on and not 

blinking. 

2. Enter “

8 3 0 #

”.  

3. Enter “



” to exit Program Mode. The yellow LED will begin blinking. 

To return the keypad to audible mode - 
1.  Put the keypad in 

Program Mode

 by entering the 

Installer Code 

followed by 

the “



”. The keypad will beep twice and the yellow LED will be on and not 

blinking. 

2. Enter “

8 3 1 #

”.  

3. Enter “



” to exit Program Mode. The yellow LED will begin blinking. 

When the keypad is programmed for 

Auto Entry Mode 

it is not necessary to 

terminate 

User Codes 

with the “

#

” during operation. However, in 

Auto Entry 

Mode

 the 

User Code 

must be the same length (4 to 8 digits) as the 

Installer 

Code

. 

To put the keypad in 

Auto Entry Mode 

- 

1.  Put the keypad in 

Program Mode

 by entering the 

Installer Code 

followed by 

the “



”. The keypad will beep twice and the yellow LED will be on and not 

blinking. 

2. Enter “

8 2 1 #

”.  

3. Enter “



” to exit Program Mode. The yellow LED will begin blinking. 

To return the keypad to 

Manual Entry Mode 

- 

1.  Put the keypad in 

Program Mode

 by entering the 

Installer Code 

followed by 

the “



”. The keypad will beep twice and the yellow LED will be on and not 

blinking. 

2. Enter “

8 2 0 #

”.  

3. Enter “



” to exit 

Program Mode

. The yellow LED will begin blinking. 

AUTO OR MANUAL CODE ENTRY MODE 

The 

Duress Output 

is not a programmable feature. The keypad automatically 

creates a 

Duress Code 

based on 

User Codes

. The 

Duress Code

 is the 

User 

Code 

with the first digit increase by 2. For example: If a 

User Code 

is “1234” then 

the 

Duress Code 

is “3234”. There are no 

Duress Codes 

created for Output 2 

User Codes

. 

When a 

Duress Code 

is entered, Output 1 will activate and the Duress Output 

will go to ground (-) and will not return to it’s normal state until a valid 

User Code 

is entered. 
The keypad does not allow 

User Codes 

to be duplicates of 

Duress Codes

. For 

example: If the 

User Code 

is “1234” then the 

Duress Code 

is “3234” and the 

keypad will not allow a 

User Code 

of “3234”. 

DURESS OUTPUT