Assa Abloy Alarm Controls KP-300, Operating Instructions Manual

8 

If the 

Installer Code

 is forgotten, the 

Direct Access to Programming (DAP)

 utility 

can be used to put the keypad in 

Programming Mode

. 

1.  Disconnect the power supply from the keypad. 
2.  Move the DAP jumper from the OFF to the ON position. 
3.  Reconnect the power supply to the keypad (keypad will start beeping). 
4.  Move the DAP jumper from the ON to the OFF position (keypad will stop 

beeping and the yellow LED will be on and not blinking. The keypad is now in 

Programming Mode

. 

5. A new 

Installer Code 

must now be entered. 

6. Enter “

0 (4 to 8 digit new installer code) #

”. For example, if you wish to 

change the 

Installer Code 

to 1 2 3 4 you would enter “

0 1 2 3 4 #

”.  

7.  The keypad will beep twice indicating that the new 

Installer Code 

has been 

accepted. 

8. Enter “



” to exit 

Program Mode

. The yellow LED will begin blinking. 

The Green LED is on while Output 1 is activated. 
The Red LED is on while Output 2 is activated. 
The Yellow LED is described in the table below - 

Yellow LED 

Keypad Status 

Tone Indicator 

On Programming 

Mode  None 

1 Blink 

Successful Key Press 

1 Beep 

2 Blinks 

Successful Code Entry 

2 Beeps 

5 Blinks 

Error in Code Entry 

5 Beeps 

Continuous Blinking 

Standby Mode 

None 

Continuous Blinking 

DAP Jumper not replaced 

Continuous Tone 

DIRECT ACCESS TO PROGRAMMING (DAP) 

LED AND TONE INDICATORS