®
ASSA ABLOY
ElectroLynx® is a registered trademark of ASSA ABLOY Inc.
Copyright © 2014 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
12
4) Installation Instructions
8
Installation (or Replacement) of Batteries, Battery Keeper & Cover (WI1 only)
1. To install the batteries, first remove the battery cover using the T20 bit provided. (Fig. 8C)
2. Unscrew the bottom screw of the battery keeper and remove the battery keeper, being careful not
to break the tabs at top holding it in place. (Fig 8A)
3. Place (6) "AA" batteries in the compartment, being careful to align polarity properly (Fig. 8B)
4. Replace battery keeper being careful to engage tabs at top to hold it in place. (Fig 8A)
5. Attach battery cover to inside escutcheon making sure to line up tabs with retaining slots in
battery cover.
6. Secure with the security screw and T20 bit. (Fig 8C)
Security Screw
T20 Bit
Retaining
Slots
Tabs
Fig. 8C
Fig. 8B
Fig. 8A
C A U T I O N
DOOR MUST REMAIN OPEN
DURING INSTALLATION.
USE DOOR STOP.
TEST
FOR PROPER
OPERATION
BEFORE
CLOSING
DOOR
