5
CL3300 Series
Installation Instructions
Cylindrical Lockset
FM533 02/20
Copyright © 2012, 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole
or in part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
Cylinder Installation (continued)
c
Interchangeable Core Removal
1. Insert key marked CONTROL and turn clockwise approximately
15˚. (Figure 10)
2. Pull core and tailpiece completely out of lever.
d
Install Standard Cylinder
1. Make sure lock is unlocked.
2. Make sure cylinder tailpiece is aligned
in same direction as cylinder bible.
3. Slide cylinder all the way into lever.
• For 6-pin cylinder: Fold retainer at
hinge and press fit retainer halves
together as shown.
• For 7-pin cylinder: Break retainer at
hinge and discard spacer section.
Also remove black cylinder spacer
from inside of chassis rollback
for clearance.
Standard Cylinder Tailpieces
Note:
Dimensions are given in inches (
"
)
and millimeters (mm).
e
Conversion Kit for Schlage
®
Cylinders with CL3300 Lockset
1. Remove threaded collar and Schlage
®
tailpiece.
2. Install CL3300 tailpiece with threaded collar.
3. Adjust collar for proper end play of plug.
Control Key
Core
Figure 10
11/16"
(17 mm)
7/8"
(22 mm)
6 PIN
7 PIN
ACTUAL SIZE SHOWN
Lever
Retainer
Cylinder
Cylinder
Bible
Cylinder
Tailpiece
Fold Retainer Halves
Actual Size Shown
For 7-pin Cylinder
7-pin
6-pin
7/8"
(22 mm)
11/16"
(17 mm)
For 6-pin Cylinder
Hinge
Hinge
Remove Spacer
and Discard
Figure 11
Figure 12
Schlage
®
Cylinder
Threaded
Collar
Schlage
®
Tailpiece
