FM566 05/21
Installation Instructions
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com •www.corbinrusswin.com
Copyright © 2021, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
Installation Instructions
•
#2 Phillips screwdriver
2
Package Contents
1
Tools Required
•
Lever release tool (provided)
•
1/8" drill bit
•
5/16" drill bit
•
2-
1/8" Bore
•
1
" Bore
• 5/32" drill bit
CLX3300 Cylindrical Lockset
1
2
6
2
5
7
8
9
10
11
12
15
3
4
13
14
16
Fig.
Description
1
Inside lever handle
2
Rose/Scalp (2)
3
Screws - latch (2) #8-32 x 3/4"
4
Inside spring housing assembly
5
Screws - through-bolt (2) #12-24
x 1-1/2"
6
Lockbody assembly with rose liner
7
Outside spring housing assembly
8
Cylinder spacer
9
Cylinder
10
Outside lever handle
11
Key
12
Lever release tool
13
Latch
14
Screws - strike (2) #12-24 x 1"
15
Strike
16
Strike box (Optional)
3
Door Preparation
DOOR
FRAME
Desired
height
above
floor
Template
Backset must
match latch
Door bevel
Figure 1
5/16" (8mm) hole
2-1/8"
(54mm)
hole
1-1/8"
(29mm)
2-1/4"
(57mm)
1" (25mm)
hole
5/32" (4mm)
2-3/4"
(70 mm)
Figure 2
IMPORTANT
•
The accuracy of door preparation is critical for proper functioning and security of this lever handle lock. Misalignment can
cause premature wear and a lessening of security.
•
Be sure to verify backset before marking and drilling door.
IMPORTANT: Deadlocking latch must stop on
strike when door is closed.
Strike
Strike Box
Attaching Screws
Strike Box
Attaching Screws
#8 -32 x 3/4"
#12 -24 x 1"
Figure 3
1. Use template FM567 to mark the door (See Figure 1).
2. Drill the door according to the template.
3. Verify the dimensions (See Figure 2).
4. Install the strike (See Figure 3)
