4
ED3400/ED3400A Series
Installation Instructions
Surface Vertical Rod
FM361 04/20
Copyright © 2020 ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in
part without the express written permission of ASSA ABLOY Access and Egress Hardware Group, Inc. is prohibited.
For installation assistance contact Corbin Russwin
1-800-543-3658 • techsupport.corbinrusswin@assaabloy.com
3
Installation
a
Template
1. Mark the vertical centerline on inside of door as follows:
• If stile is 4-1/2
"
wide or greater, measure 2-3/4
"
from doorstop.
• If stile is less than 4-1/2
"
wide, make A equal to 1/2 the width of
the exposed lock stile (when door is closed against stop).
2. Measure 37-5/8" above finished floor and draw horizontal line for
active case template.
3. Align template (T31207) for active case with centerline and tape.
4. Using crossbar hole centers for measuring, draw vertical centerline of
inactive case.
5. Measure 38-5/8" above finished floor and draw horizontal line for
inactive case template (1" higher than the active case).
6. Align template (T31206) for inactive case with centerline and tape.
7. Position top strike template (T31209) into place.
8. Center punch mounting holes for active and inactive case,
and top strike.
9. Drill and tap holes in door, per templates.
Figure 4
TEM
PLATE
T3120
7
TEMPLA
TE
T3120
6
TEMPLA
TE
T31209
Top latch
template
Door stop
38-5/8" Above
finished floor
37-5/8" Above
finished floor
Vertical for top latch,
bottom latch and active case
CL
Horizontal of inactive case
holes
CL
L
C
Vertical for top latch,
bottom latch and active case
CL
A
Inside
face of
door
Finished Floor
5/8"
Max
Figure 3
