ED5000N (S)(A) Series Exit Device
15
Copyright © 2018 Corbin Russwin, Inc. All rights reserved.
Reproduction in whole or in part without the express written
permission of Corbin Russwin, Inc. is prohibited.
8) Surface Vertical Rod Installation Instructions (Continued)
3.
Attach Connectors (Interior PCB Assembly)
a. Connect P5 (7-pin connector) from Reader board to J5
on interior PCB assembly (Fig 3a and 3b).
b. Connect ElectroLynx harness (4 and 8-pin) from door
harness to ElectroLynx harness on interior PCB assembly
(Fig 3a and 3b).
c. Connect P3 (2-pin connector) from lockbody to J3 and
P4 (6-pin connector) from lockbody to J4 on interior PCB
assembly (Fig 3a and 3b).
NOTES:
Neatly fold the wires onto themselves and into the remaining
space along side the mounting bracket to prevent pinching wires
when mounting escutcheon.
Connectors go on only one way.
Do not offset connector and be sure they are completely seated.
PCB Layout - Wire Assignments - ElectroLynx Assembly (Molex)
J2
J1
1-Violet Lock
DC Neg
(Solenoid, neg)
3 - Pink
NOT
USED
1- Black
PWR GND
3-White
Wiegand
DATA 1
5-Orange
RX (N/O)
7-Brown
EGND
2-Gray, Lock
DC Pos
(Solenoid, pos)
4-Tan
NOT
USED
2-Red
PWR 12VDC
4-Green
Wiegand
DATA 0
6-Blue
RX (COM)
8-Yellow
LED
From Reader
Board P5 to J5
From Electric
Trim
Body P3 to J3
From Chassis
Body P4 to J4
To ElectroLynx Harness
J2
Fig. 3a
J5
J4
J3
J1
From Reader
Board P5 to J5
From Electric
Trim
Body P3 to J3
J5
J4
J3
1
2
3
Fig. 3b
From Chassis
Body P4 to J4
To ElectroLynx
Harness
Mounting Bracket
Mounting Plate
(2) Mounting
Plate Screws
1
3
2