IN100 Cylindrical Lock
13
Copyright © 2016 Corbin Russwin, Inc., an ASSA ABLOY Group company.
All rights reserved. Reproduction in whole or in part without the
express written permission of Corbin Russwin, Inc. is prohibited.
5) Installation Instructions (Continued)
10. Installation of Connectors
Secure the following connectors to their respective terminals (Fig. 10D):
A. Secure the 4-pin DPS connector.
B. Secure the 10-pin lock body assembly connector.
CAUTION - Do not touch or allow debris to enter connector contacts.
IMPORTANT: Do not run wires through bottom hole in plate - it will
damage wires and the controller connector.
Route wires around flange, do not route wires through
the flange hole (Fig. 10B, D).
E. Secure the 24-pin card reader connector (Fig. 10F).
Ground
Lug
DPS (4-pin)
A
Lock
Body
(10-pin)
Fig. 10D
B
Reader
(24-pin)
Board-to-Board
Connector
Fig. 10F
D
D. Secure the mounting assembly while ensuring proper
alignment of outside reader and tighten the (2) through-bolts
on the inside of the door to secure the reader (Fig. 10E).
Secure Mounting Plate
*NOTE: Optional 2-pin external 9-24VDC power connector.
9-24VDC
Power*
C. When all connections have been made, tuck excess cable
into wire hole on inside of door.
Fig. 10E
Fully
tighten
