41
The warranty on Corbin Russwin products becomes void if the product is modified in any way, regardless of whether the modifications causes or contributes to any alleged defect. If a
Corbin Russwin product is modified it may no longer meet industry certification and quality control standards applicable to the original product and is no longer a genuine Corbin Russwin product.
Copyright © 1999-2018, ASSA ABLOY Access and Egress Hardware Group, Inc. All rights reserved. Reproduction in whole or in part without the express written permission of ASSA ABLOY Access
and Egress Hardware Group, Inc. is prohibited. Patent pending and/or patent www.assaabloydss.com/patents.
Service Procedures
UT5200 Parts Manual
Changing Hand of Lockset
Lever Version
Because levers are handed, it is not practical to print detailed
hand changing instructions. There are too many variations,
depending on function and cylinder options.
Use chart below to determine what parts and labor are
necessary for the conversion you are attempting. Then, for
specific service instructions, refer to previous pages devoted to:
• Disassembly of lever version
• Changing the hand of the knob version.
Note:
New levers must be obtained when making the changes in the second half of the diagram below.
Levers are Same
(UT5210, UT5272, UT5282, and non-IC UT5251, UT5261)
Between LH and
RH or between
LHR and RHR
Between LH and
LHR or between RH
and RHR
Between LH and
RHR or between
RH and LHR
Switch
internal lever
components.
Switch
internal lever
components and
reverse spindle
and/or hubs
inside chassis
Switch
internal lever
components and
reverse spindle
and/or hubs
inside chassis,
but install levers
back on
original
side of chassis
Levers are Different
(UT5220, UT5255, UT5257, and IC UT5251, UT5261)
Between LH and
RH or between
LHR and RHR
Between LH and
LHR or between RH
and RHR
Between LH and
RHR or between
RH and LHR
Transfer internal
components of
old levers into
NEW LEVERS
of opposite
handles
Transfer internal
components of
old levers into
NEW LEVERS
of opposite
hands and
reverse spindle
and/or hubs
Transfer internal
components of
old levers into
NEW LEVERS
of opposite
hands reverse
spindle and/or
hubs, but install
levers back on
original
side
of chassis
