Installation Instructions
Jamb Mount Application
Jamb Mount
CEILING LINE
3
(76)
1-3/4
(44)
MIN.
MIN.
MOUNTING SCREW SPECIFICATIONS
or
Sex nuts, Option
M54, furnished
when ordered
L
3/8”
(10)
1/4-20 THREAD
Drill thru 9/32 (7.1) Enlarge to
3/8 (9.5) Dia. This Side Only
(4 Places)
DOOR
THICKNESS
SEX NUT
LENGTH “L”
1-3/8 (35mm)
"
1-3/4 (44mm)
& OVER
"
1-9/32 (33mm)
"
1-21/32 (42mm)
"
}
{
Mark Door and Jamb
(for closer bracket and arm bracket)
use dimensions in template below.
1. Template
OPENING
MAXIMUM
A
B
8-7/8
(225)
13-3/8
(340)
HINGE
CONDITION
7-3/8
(187)
11-7/8
(302)
7-3/8
(187)
11-7/8
(302)
5-7/8
(149)
10-3/8
(264)
Butts, Offset
Pivots, and
Swing Clear
Hinges
110°
140°
180°
140°
CENTER
HUNG
*
Dimensions “A” and “B” are taken from
centerline of hinge as shown and apply to
pivot point of swing clear hinges. Offset
and centerhung pivots.
*Must be single acting door.
2. Install Closer Bracket to Jamb
Pin Hole End
Countersunk
Hole End
Page 6
Holding Pins
3. Mount Closer Body to Closer Bracket
NOTES:
Check hand of door, see page 1.
Right Hand Application Shown. Left Hand Opposite.
Dimensions given in inches (mm). Do Not Scale Drawing.
Closer must be installed in a true horizontal plane to ensure proper closer performance.
All degrees of door opening are dependent upon door, frame, wall and hinge/pivot conditions permitting.
1-9/16
(40)
A
FRAME
STOP
TOP OF
DOOR
CLOSER
BRACKET
2-1/4
(57.2)
ARM BRACKET
FRAME
LINE
B
FRAME
TOP OF FRAME
ARM AND CLOSER BRACKET
1/4-20 oval head machine
screw or 1/4-14 self-drilling
screw. 3/16 (4.8) diameter
pilot hole required for Wood
Applications.
1/2
(12.7)
4-5/16
(109.5)
1
(25.4)
1/4-20 x 1/2 OHMS (2)
1/4-14 x 1-1/2 OH Self-Drilling (4)
®
ASSA ABLOY
80-9330-3000-152
Rev. 05/12
DC3220 Series
