19
EN
Functions
Resetting to normal operation
The system must be reset for normal operation after an Emergency unlock or a
safety-related fault.
Resetting to normal operation is possible after 60 seconds if no Emergency re-
lease commands are present and/or all causes of faults have been eliminated.
A function test is performed automatically depending on the cause of fault. If the
fault has been corrected and functionality has been re-established, the escape
route securing system will be locked in order to test the
Hi-O Technology
™
components.
If release commands are to be executed, the systems will be unlocked again;
otherwise the Locked status remains in effect.
If the function test shows that a fault remains, the cause can be determined in
detail with the external
display module 1386D00-DISP
.
Warning!
Danger arising from tampering or improperly performed repairs:
If the
ePED
®
terminal 1386-00
or parts of the device cannot resume normal operation after a
fault or alarm message, or if there is evidence of damage, the device may only be
repaired by a qualified person. Please contact the customer service of the installa-
tion company or the support department of
ASSA ABLOY Sicherheitstechnik GmbH
("Warranty," page 59).
Combination inputs
Additional functions can be executed with combination inputs. Combinations
inputs are activated via electrical contacts.
Potential-free contact of the on-site electronic access control system:
Locked
status
·
Temporary release
start
· Temporary contact <= 2 seconds
Locked
or
Temporary release
status
·
Permanent unlocking
start
· Temporary contact > 5 seconds
Permanently unlocked
or
Temporary release
status
· Lock = Temporary contact
Emergency unlock
or
Fault
status
· Resetting to normal operation = Temporary contact
!
