www.assaabloy.co.nz
2
Introduction
3
Lock is
not-responding:
4
What if I don’t have enough wires for 3-Wire Control?
4
2-Wire Control
5
3-Wire and
2-Wire
Control
Diagrams
5
Lock is not locking according to the way I have set the switches
6
Lock is remaining in powered state even when I send a lock / unlock signal
6
I am trying to set the lock up as double access (1 side PtL, 1 side PtO) but it is not working as expected
6
Lock single
beeps
every
2
seconds
7
Lock beeps once or twice every time the lock locks
7
Lock beeps
three
times
on
start
up
7
Lock double
beeps
every
6
seconds
8
Deadlatch monitor
is
not
working
8
REX (Request
to
Exit)
is
not
working
8
Door position
switch
is
not
working
8
Lock status
monitor
is
not
working
9
LED is
not
active
9
LEDs turn
off
after
10
seconds
9
LED is
not
visible
after
fitting
furniture 9
LED shines red briefly and then green after sending unlocking signal
9
There is no room for the cable when installing in a timber door
10
Can I leave a USB cable connected to the lock but power it via the main connector
10
I have old LED furniture that I would like to re-use, is there an adaptor kit
10
I have an old 3582EL to replace, is this lock interchangeable
10
I have a retro-fit with LEDs (power is being sent on old green wire to continuously power LEDs),
will
I
have
to
re-wire
the
installation
11
I am trying to set the LEDs on site, how can I power the lock
11
I am trying to lock one side of the lock but the cabling has not been installed – how can I do this
11
Content
