04/30/21
Copyright © 2016, 2019, 2021, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
IN120 / IN220 Exit Device
1-800-810-WIRE • www.sargentlock.com • A8185D
29
5 Supplying Power to the Controller
Fig. 5A
Important - before inserting PoE plug into PoE connector, apply dielectric grease to top
of plug, covering the pin area (Fig. 5A).
1. Once controller is securely in place, connect RJ45 male
connector to female RJ45 port on controller board (Fig. 5A).
2. If power is enabled, LED will flash and lock motor will cycle.
A. IN220 (PoE)
1. Insert bottom tab of controller (ensure a clear path) into slot on mounting plate (Fig. 4D, E).
2. Ensure proper alignment of board-to-board connectors (Fig. 4E) while pivoting controller toward door
until two tabs on top snap securely into place on mounting plate (Fig. 4D).
CAUTION
: To avoid possible damage to board-to-board connectors, care should be taken when securing
controller to mounting plate. If there is resistance when securing, detach controller to determine
cause before re-attaching controller.
4 Installing the Controller (Continued)
Fig. 4E
Fig. 4D
Controller
Click
into
place
Apply grease
