03/31/15
1-800-810-WIRE • www.sargentlock.com •
A7786G
11
Copyright © 2015, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
Profile Series v.S2 WiFi Mortise Lock
5 – Install Gasket (for Exterior Doors)
For exterior applications, use weather seal gasket between escutcheon
and outside door surface. To apply weatherseal gasket:
1. Carefully remove the backing from the gasket. (Fig. 5A).
2. Apply gasket to escutcheon:
a. Starting in one place, press the adhesive side
of the gasket firmly against the escutcheon.
b. Work around the escutcheon, pressing the
sticky side of the gasket firmly against the
escutcheon edge.
c. The gasket should be aligned so that all edges
of the escutcheon are covered.
3. Attach escutcheon to the door.
Note: The 43 cylinder may be used with or without a gasket.
6 – Position Outside Escutcheon for Installation
1A. For fire rated doors:
feed ribbon cable with connector and ground wire
from outside of door through weatherseal gasket and fire stop plate (Fig. 6A).
Note: Install ribbon cable with cable exiting down
1B. For non-fire rated doors:
feed ribbon cable with connector and ground
wire from outside of door through weatherseal gasket (if used)
and weather conduit (Fig. 6B).
Note: Install ribbon cable with cable exiting down
2. With outside lever horizontal, locate the outside escutcheon on the door,
while directing the mounting posts through the door and lock body (Fig. 6B).
Make sure the lever spindle is properly engaged in lock.
7. On the inside of the door, insert spindle into square hole
of mortise lock.
8. Slide inside adapter and plate
assembly over spindle and loosely
secure with 2 through -bolt
screws (#8-32 x 5/8”).
Inside of Door
Mortise Lock body
and AX Connectors
Fig. 6B
Reader
Cable
Ground
Wire (E1)
Antenna
(iCLASS)
Fig. 5A
Keypad
Ribbon
Cable
Ground
Wire
(E1)
Gasket
Antenna
(iCLASS)
Only
Fig. 5B
Antenna
(iCLASS
only)
Fig. 6A
Outside of Door
Keypad
Ribbon
Cable
Ground
Wire (E1)
Install Outside Escutcheon
Scan to see a video of this
installation step.
