03/31/15
1-800-810-WIRE • www.sargentlock.com •
A7786G
13
Copyright © 2015, Sargent Manufacturing Company
, an ASSA ABLOY Group company
. All rights reser
ved.
Reproductions in whole or in part without express written permission of Sargent Manufacturing Company is prohibited.
Profile Series v.S2 WiFi Mortise Lock
Mortise
Connector
Ground
Wire
Fig. 8B
Back
1
AX/DPS
2
Inside of Door
1
2
Outside
Escutcheon
Antenna
Unused
TB1
Reader
Ribbon Cable
Fig. 8A
Tabs
Retaining
Slots
1. Remove the cover from the inside escutcheon by removing the
security screw with the provided tool (Fig. 8A).
2. Attach the reader assembly ribbon cable into the back of the
controller assembly - the side that faces the door surface when
mounted (Fig. 8B).
3. Attach the antenna to the circuit board in the plastic housing
under the controller assembly.
Note: The difference between the wiring for the iCLASS 13.56
MHz reader and the 125 kHz Prox is that the iCLASS wiring
includes an antenna wire.
4. Attach the ground wire to the bottom of the controller
assembly (Fig. 8B).
5. Connect the cable from the mortise lock to the bottom of the
controller assembly (TB1, Fig. 8B).
6. Connect the AX/DPS connector to the 2-pin harness.
8 – Escutcheon Wire Connections
Images are shown without gasket. If gasket is necessary,
refer to 5.
Before the controller is attached to the door:
Inside Escutcheon
Connections
Scan to see a video of this
installation step.
