2
of 4
Mounting
the Back Plate
1.
Level and mark the desired
placement. Clean the mounting
surface with provided
alcohol swab. Remove
reader from backplate.
2.
Cut the VHB tape into
two pieces and apply tape
as shown in Diagram 3.
Mount backplate to marked
location and apply pressure
to activate tape adhesive.
NOTE:
VHB tape is intended to be
used on glass and non-porous metal
surfaces. For all other surfaces, use
an appropriate adhesive and follow
the manufacturer’s instructions.
3.
Install batteries (Diagram 4) .
4.
Secure reader to backplate.
NOTE:
Ensure reader is fully seated
against the backplate and the screw hole
is properly aligned before securing.
Micro USB Port
For emergency power & local
(hard wired) firmware updates,
use micro USB port located on
the side of the R100 reader.
Diagram 3:
VHB Placement & Mounting
Diagram 2:
Mark Placement & Remove Back Cover
Diagram 4:
Install Batteries & Secure Reader
Diagram 5:
Micro USB