Product Layout:
Reminder: Please keep in/out panel inside clean when install
Please keep internal/external panel clean before installation
2
3
Battery Cover
Battery Box
Reset Button
Inside Handle
Night Latch
Snib
Installation
Screw
Installation
Screw
Key Cover
Outside Handle
Fingerprint
Scanner
Door Bell
RFID Card
Scanner
Keypad
180°
1.Use a cross
screwdriver to
unscrew the
handle screw
in the square
hole.
2.Pull out handle and rotate
it 180° clockwise or
counterclockwise, then
reinstall to the original posi-
tion and tighten the handle
screw.
1.Push
latch in.
2.rotate latch
180
°
.
3.Confirm
in/out side,
screw always
go along
with inside
panel, if
required to
reverse,
please screw
out and
screw in other
side
and fix it
properly.
Change
handle
direction
Lock
body
change
direction
Outside panel
Inside
panel
Screw
Battery box
cover
Lock body guide post
Screw
Spindle
Lock body
Lock body screw
Panel screw stud
1
.
Change handle & Lock Body opening direction, if necessary according to the door.
2
.
Put Lock body in cavity and tighten the lock body with installation screws.
.
3
.
After inserting spindle in square hole, make sure outside handle, spindle, lock core
& lock core hole all are in correct position and then tighten the outside panel on the
door.
Panel and lock body installation step:
Internal Panel
External Panel
When connecting front & back panel, make sure connecting wise is not left outside.
