Assa Abloy Yale Assure Lock YRC226, Installation And Programming Instructions

32

P/N

-

-

-

Rev G

YRL EMICL TSINSTL FUL

Definitions

All Code Lockout Mode:

This feature is enabled by the Master code. When enabled, it restricts all user (except

Master)

code access. When attempting to enter a code while the unit is in Lockout, the

locked padlock will

PIN

RED

appear on the screen.

Automatic Re-lock Time:

After a successful unlock, the unit will re-lock automatically after duration selected in the

Advanced Lock Settings

(Main Menu selection #3).

Handing the Lock:

Lock handing refers to which direction the bolt comes out of the door (right or left). If the lock

was programmed off the door, the lock may need adjusting. Review Handing the Lock instructions and/or Re-
Handing instructions listed in Hardware Troubleshooting.

Inside Indicator Light:

Located on the interior lock. Shows active status (Locked) of lock and can be enabled or

disabled in the

(Main Menu selection #3).

Advanced Lock Settings

Language Setting Mode:

Choosing English (1), Spanish (2) or French (3) becomes the (default) setting for the

lock's voice prompts.

Low Battery:

When battery power is low, the Low Battery Warning indicator flashes

. If battery power is

RED

completely lost, use the cylinder key override.

Master

Code:

It must be created prior

PIN

The Master

code is used for programming and for feature settings.

PIN

to programming the lock.

The Master code will also operate (unlock/lock) the lock.

Network Module Setting:

With the optional Network Module installed, this setting becomes available thru the Main

Menu (7) and allows the lock to connect with a network controller.

One Touch Locking:

When the latch is retracted, activating the keypad will extend the latch (during Automatic Re-

lock duration or when Automatic Re-lock is disabled). When One-Touch Re-lock is

in use

any valid

not

(disabled),

PIN code will re-lock the lock.

Previous:

While in Menu Mode, pressing this icon cancels the current operation and returns the user to the

previous step.

Privacy Mode:

Privacy mode is disabled by default. Enable Privacy Mode by pressing the privacy button for 4

seconds to put the lock in do-not-disturb mode (all pin codes are disabled).

Shutdown Time:

The unit will shutdown (flashing

) for sixty (60) seconds and not allow operation after the

RED

wrong code entry limit (5 attempts) has been met.

Tamper Alert:

Audible alarm sounds if attempting to forcibly remove outside lock from door.

User

Code:

PIN

The User code operates the lock. Maximum number of user codes with Z-Wave Plus or ZigBee

network module is 250; without network module or with iM1 network module, maximum is 25; with Bluetooth,
maximum is 12. Note: When deleting user pin code(s), screen will display user pin code being deleted.

Volume Setting Mode:

Low (2)

The volume setting for

code verification is set to

by default; otherwise it can be

PIN

set to

or

for quiet areas.

High (1)

Silent (3)

Wrong Code Entry Limit:

After five (5) unsuccessful attempts at entering a valid

code, the unit will shut down

PIN

and not allow operation for sixty (60) seconds.