Assa Abloy Yale AYRD110, User Manual

18

P/N

-110-

-

-

Rev D

AYRD

STANDALONE INST FUL

Programming Troubleshooting

Symptom

Suggested Action

Lock does not respond –
door is open and
accessible.

• Press each keypad button for response when pressed.
• Check batteries are installed and oriented correctly (polarity)

in the battery case.

• Check batteries are in good condition; replace batteries

if discharged.

• Check to see if cable is fully connected and not pinched.

• Batteries may be completely discharged.
• Apply 9V battery to terminals below the keypad for backup

power option.

Unit chimes to indicate
code acceptance, but the
door will not open.

• Check to see if there is another locking device on the door.
• Check the door gaps for any foreign objects between door

and frame.

• Check that the cable is firmly connected to the

board.

PC

Unit operates to allow
access, but will not
automatically re-lock.

• Check to see if Auto Re-lock Mode is enabled.
• If low battery indicator is lit (see below), change batteries.

PIN codes will not register.

• PIN codes must consist of 4 to 8 digits to register.
• The same

code cannot be used for multiple users.

PIN

• Registration/management of

codes is set by the

PIN

authority of the Master Code.

• Contact the Master user.
• User codes must be entered within 5 seconds or the

process will have to be restarted.

• Check mark

or gear

cannot be used as part of the

Upon entering a

code

PIN

and pressing the (*) key, the
lock gives a series of beeps,
flashes red & blue

s 7

LED

times, and does not unlock.

• All Code Lockout Mode is enabled.
• Only the Master can enable/disable All Code Lockout Mode.
• Contact the Master user.

Upon entering a

code

PIN

and pressing the (*) key,
there are different tones.

• Check to see if the lock is set to All Code Lockout Mode.
• Setting/managing All Code Lockout Mode is done through

Master Code only. Contact the Master user.

The unit operates, but it
makes no sound.

• Enable Audio Mode.

The unit displays inter-
mittent

flashes.

RED

• This is the Low Battery indicator alerting that it is time to

replace the batteries. Replace all four (4) batteries with
new

Alkaline batteries.

AA

Upon entering a

code

PIN

and pressing the (*) key,
the unit responds with a
series of beeps and the
keypad flashes three times.

• The digits entered were incorrect or incomplete. Re-enter

the correct code followed by the check mark (*) key.

Lock does not respond –
door is locked and
inaccessible.

code.

PIN