Assa Abloy Yale eBoss 8850FL Series, Installation Instructions Manual

An ASSA ABLOY Group brand

80-9086-0050-010 (10-12)

11

2  

Minimize gap 

    between keypad 
    and escutcheon 
    by gently pushing 
    them together, 
    then tighten both 
    controller board
    screws.

IV-E  Installing the battery escutcheon and adjusting for appearance

Installing the Battery Escutcheon and
minimizing the clearance between the
Battery Escutcheon and the Small Rose
Escutcheon.

1. **Dry fit the Battery Escutcheon
    to the Small Rose Escutcheon.
NOTE: IT IS VERY IMPORTANT TO KEEP
            WIRES FROM GETTING PINCHED
            WHILE ATTACHING BATTERY
            COVER.
2. Check the clearance where 
   the two meet, see top picture. If 
   the clearance is acceptable tighten 
   the Battery Escutcheon screw.

3. If the clearance is too great 
    loosen the Small Rose Escutcheon 
    screw then push up and re-tighten the
    screw.  Recheck clearance.
    If the clearance is still not acceptable
    remove Battery Escutcheon and loosen
    the two Controller Board screws and
    adjust the controller board up or down.
    Re-tighten controller board screws and
    refer to step #2.

**Battery Escutcheon

Battery 
Escutcheon
Screw

**Hook

** Battery Escutcheon has a machined 
slot that engages the hook at the top of 
the Controller Board prior to mating up 
with Rose Escutcheon.  

1

All Applications

Small Rose Escutcheon
and Screw

3