An ASSA ABLOY Group brand
80-9086-0050-010 (10-12)
7
Steps
a) Route keypad harness thru hole “E”, all the way thru door.
b) Route keypad post thru hole “G”.
2. Install O/S long escutcheon posts in holes “D” and “H”. This will hole the keypad in place.
3. Install short plastic spacer with flat down in hole “H” on inside of door.
4. Securely fasten the #10-24 X 1-1/4 screw thru the short plastic spacer.
5. Install the tee nut from the inside of the mortise pocket thru hole “I”. See template.
6. Install long plastic spacer with flat up in the back of the controller board.
7. Secure grounding strip to door making sure the strip connects the controller board to the I/S Short Esc.
8. Loosely fasten the controller board to the tee nut using #10-32 X 1 screw thru the
long plastic spacer.
9. Loosely fasten the top of the controller board using #10-32 X 1 screw thru hole “G”.
1. Install keypad housing:
"
"
"
Section IV Installing Assembly on Door
1
5
7
8
6
4
3
2
IV-A Installing keypad, long escutcheon and controller board
Tee Nut
Install thru hole “I”
see template
Non-Cylinder Applications
8850FL & 8852FL
Controller Board
for 8852FL
Controller Board
for 8850FL
G
H
E
A
D
Grounding Strip
9