6
An ASSA ABLOY Group brand
80-8420-0900 Rev. B (05-08)
1. If the Standard Cylinder has to be Removed
for Re-Keying see Below:
Lever
Handle
#1802
Cylinder
Retainer
Spring Pad
14-5407-9034
Cylinder Spacer
(Must be used with
6 Pin Cylinder Only)
14-5407-9201
Schlage®
Cylinder
Threaded
Collar
Schlage® Connecting
Bar 14-5407-1039-059
(See Cylinder Data Above)
Schlage® Cylinder Cam
14-5407-1036-048
For Schlage®
Removable Core
match driver position
in handle to the
sketch below for
proper alignment.
Roll Pin
99-9999-3942-999
(.094 Dia. x .375)
1. Remove threaded collar and Schlage® tailpiece.
2. Install Connecting Bar with threaded collar.
(Adjust collar for proper end play of plug.)
3. Slide Cylinder Cam onto Bar. (Note orientation of
notch.) Fasten with roll pin.
4. Slide shell sleeve onto cylinder.
5. Properly Size the cylinder (See above)
Follow instructions above to install cylinder
into lever handle.
Shell Sleeve
14-5407-9101-999
To Remove Cylinder from Handle
1. Remove retainer spring pad.
2. Slide cylinder out of handle.
To reassemble reverse
procedure. (Be sure spacer is
installed on back of cylinder
plug.) Water may br used to
lubricate spring pad to aid
installation.
11/32
(8.7)
For Yale®
7 pin cylinder
cut to 11/32” as shown
Retainer Spring Pad
90°
Correct position of
Schlage
®
Connecting
Bar when assembled
toward free end of
handle
Verify Cylinder Tailpiece
Length (See Below).
Yale® Conversion Kit E107S
For Schlage® Cylinders
When used in 896F Locks
To Install Connecting Bar
II
-D Re-Keying
Competitor Cylinders
The cylinders furnished with the 896F are a special length. Cylinders that are not ordered with this
lock will be too long. This includes 1802, E1802 and competitor cylinders. Failure to trim these cylinders
will result in damage to the lock. Use the above graphic to properly size the cylinder assembly before use.
2-9/16" (65.5) For 6 pin cylinders.
2-3/8" (60.5) For 7 pin cylinders.
1-1/32" (26) For 6 pin cylinders.
7/8" (22) For 7 pin cylinders.
Standard
6 & 7 Pin
Cylinder
Data
EXTREMELY
IMPORTANT!!
*
*
