8
An ASSA ABLOY Group brand
80-8420-0900 Rev. B (05-08)
III-C
. INSTALL ELECTRONIC COMPONENTS
III-B
. EXIT DEVICE HEAD COVER INSTALLATION
Route wires
thru Slot in
the cover
Insert Plug
Step 4 Install the plug in the bottom notch of the exit device
cover as shown in figure 6.
Step 5 Slide the cover onto the head while routing the
wires through the top notch in the cover. Use
caution so the wires are not pinched between
the cover and the surface of the door.
Step 6 Install the two cover screws.
Step 7 Slide the keypad and motor harnesses out of the
way as shown (see figure 7).
Step 8 Hold the inside electronics assembly up to the
inside of the door above the device cover and
install the #10-32x 1-1/2 long screw thru the slot
in bracket. The screw threads into the sexbolt on
the outside trim assembly. Snug the screw so that the
head of the screw is centered in the slot.
Step 9 See the picture on page 9 and connect the keypad
and motor harnesses to the board as shown.
Step 10 Dry fit the electronics cover to the electronics
assembly. Reposition the electronics assembly as
needed. Once the desired clearance is obtained
between the electronics cover and the device
head cover tighten the #10-32 screw. Set the
cover aside and install the combination screws
thru the bracket to provide additional strength.
Step 11 Remove the battery tag and reinstall the battery.
At this point the unit will make a beep signaling
it is ready.
Step 12 Install the electronics cover using the short #8-32
flathead screws.
Step 13 Inspect your work. Insure everything was installed
correctly.
Step 14 Install the strike and any other components per
the exit device instructions.
REMOVE
BEFORE
USE
Figure 6
Figure 7
Battery Tag
“Remove Before Use”
#10-32 Screw
Note:
If exit eBoss® was not ordered with a 7100 or 2100 Series
device the slot in the head cover may need to be added
prior to cover install. Refer to page 10 for proper slot
dimensions. If the device was ordered with the trim see
the below steps.
