Assa Abloy Yale Essential Series, User Manual

Essential Series

Essential Series

12.Extension Functions  

9V external battery is used in emergency, eg the power failure. Please  

 connect the 9v external battery electrodes with the electrodes of the lock 

for seconds as the picture shows, then you can operate the lock. 

12.1

 9V External Battery (Available when electrodes exist on the bottom  

surface of the front lock body) 

12 

13

12.3  Audit Trail 

Setting Date and Time:
Press: 7 + # + Master Code + “YY/MM/DD/HH/MM” 
(twice, 24-hour system) +  # 

Eg. 2012-6-18,  22:30pm,
Press:  7 + # + 11   “1206182230”   “1206182230”  +   # 

Operation

12.2 Enabling/Disabling Passage Mode

Note: 

Under passage mode, you can unlock it by touching the screen.

Example

Press “**”

Press “**”

Press

#

“ ”

Press

#

“ ”

Input “Master Code”

Input “12345678”

Check Date and Time:
Press:  7 + # + Master Code +  #

Reading Fingerprint Records:
Press: 6  +  *  +  Master Code  +  #
records will be shown on LCD screen.

Reading Code Records:
Press: 7  +  *  +  Master Code  +  #
records will be shown on LCD screen.

Reading Card Records:
Press: 8  +  *  +  Master Code  +  #
records will be shown on LCD screen.

1. 600 recordscan be stored in the lock.
2. After the records are shown on LCD screen,
press “*” means “page up”;
press “#” means “page down”;
press “0” means “back to 1st record”;
press any key to extend display time. 

13. Solutions for Common Error 

Phenomenon

Cause

Solution

2.The fingerprint might be deleted

To Enroll the fingerprint again

2.The fingerprint is damaged

1.The fingerprint is pressed 

   incorrectly

2.Enroll the fingerprint with another 
   finger

1.Try to press the fingerprint in correct
   location   

Four beeps sound when opening the door Low battery voltage

Change the batteries

No response when pressing the buttons

No battery

Change the batteries

Often fail to verify the fingerprints

1. The finger is too dirty/dry/wet

.The scanner is too dirty

2

1.Clean/ Moisten/ Wipe the finger
2. Clean the scanner

Fail to enter the enrollment or deletion 

mode

1.The code for enrollment or 
   deletionis not the master code.    

2.The operational procedure is 

   incorrect

1.Confirm that you enroll or delete with  

the master code

2.Review the instructions

Place the finger on the scanner, the red 

light  is on with three short beeps, and 

fail  to open the door 

Open the door with a valid fingerprint, the 

red light is on with three short beeps, and 

fail open the door

1.The fingerprint might not be 

    enrolled

YDME - 90

YDME - 90