P/N YRD136-MNL-0008 Rev C
16
Definitions
All Code Lockout Mode: This feature is enabled by the Master code. When enabled, it restricts all user (except Master) PIN code
access. When attempting to enter a code while the unit is in Lockout, the lock rapidly beeps 5 times.
Audio Mode: Choosing Disable (3) in Audio mode shuts off the code confirmation tone play-back for use in quiet areas. Audio
mode is enabled or disabled through feature programming by the Master code.
Automatic Re-lock Time: After a successful code entry or manual unlock with the key, the lock will automatically re-lock after
each unlock in an effort to keep your home secure. This feature is optional, and can be turned off. In the ON mode, the lock will
automatically re-lock after thirty (30) seconds.
Master PIN Code: The Master PIN code is used for programming and for feature settings. It must be created prior to
programming the lock. The Master code will also operate (unlock/lock) the lock.
Network Setting: This setting is available through the wireless button on the interior escutcheon and allows the lock to connect
with a network controller.
One Touch Locking: When the latch is retracted, activating the keypad will extend the latch (during Automatic Re-lock duration or
when Automatic Re-lock is disabled).
Tamper Alert: Audible alarm sounds if attempting to forcibly remove outside lock from door.
Shutdown Time: The unit will shutdown (flashing keypad) for sixty (60) seconds and not allow operation after the wrong code
entry limit has been met.
Low Battery: When battery power is low, the Low Battery Warning Indicator flashes RED. If battery power is completely lost, use
the 9Volt battery override. To use the 9V battery override apply 9V battery, in either direction, to terminals below the keypad for
backup power option. Wake up the lock and enter your pin code to unlock the door.
User PIN Code: The User code operates the lock. Maximum number of user codes is 250 in network.
Wrong Code Entry Limit: After five (5) unsuccessful attempts at entering a valid PIN code, the unit will shut down and not allow
operation for sixty (60) seconds.
