18
5.2.3 Power on the receiver. The LED will begin fast flashing red too.
5.2.4 After a few seconds, the system should connect. The LED both side should go solid green, which
indicate the system has been connected.
5.2.5 Remove the bind plug and store it in a convenient place.
5.2.6 Finished. You X8 2.4GHz radio system is ready to use.
5.2.7 The receiver recognizes that module now. If you needn't use this receiver to another X8 RF Module
or not meet an accident, needn't “Binding” again.
Note:
CH2 stick position is different when use different Transmitter (such as in Futaba Tx, it’s Elevator Channel;
in JR’s Tx, it’s Aileron Channel, etc) or different operate way( such as Left Hand way or Right Hand way.
If you don’t clearly know which stick is CH 2, you can try pulling each stick at the first time, when one
stick’s move is right, the RF Module’s LED will fast flashing. Otherwise, this LED light as solid red or
green.)
