17
5)
The Setting is completed then reboot the system
WPS Mode setting
Wi-Fi Protected Setup or WPS is a feature that allows the device to authenticate to your
wireless network, the USB Device Server supports WPS Push Button and PIN
Configuration. When using WPS make sure your wireless router or access point supports
these features. The WPS Push Button Configuration or PBC can be initialized from a
virtual button following the steps below or from a physical button located on the side of
the unit. Please refer to Product Hardware Features section for more information.
There are 2 ways to install the USB Device Server. The easiest way is to use Wi-Fi
Protected Setup (WPS) Push Button Configuration (PBC) setup. This feature allows you to
setup your USB Device Server with your wireless network with just a push of a button.
Wi-Fi Protected Setup (WPS) Push Button Configuration (PBC) Setup
Note:
•
Make sure your wireless router or access point supports WPS (Wi-FI Protected Setup)
PBC (Push button configuration).
•
The USB Device Server must be placed in a location where it can still establish a
wireless connection to your wireless network. The most ideal locations are areas
where wireless adapters can maintain a 2-3 bars or 30-20% connection rating.
•
Verify that any software that is required to operate your printer or multi-function
printer is installed before installing the USB Device Server
•
The utility must be installed on each computer in order to use your multi-function
printer.
1)
Place the print server in the desired location. The USB Device Server must be placed
in a location where it can establish a wireless connection to your wireless network.
The most ideal locations are areas where wireless adapters can maintain a 2-3 bars or
30-20% connection rating.
2)
Plug in the power adapter and connect the print server. Move the power switch to
the “On” position.
