13
:: Shocks Build - Bag G-GG - Step 2
:: Shocks Build - Bag G-GG - Step 3
Front
Shock
Front
Shock
Rear
Shock
Rear
Shock
6440
Off-road shock
rebuild kit
6429
Shock
assembly
tool
x2
x2
5407
Red o-ring
6449
Shock body,
front (0.56)
6446
Shock body,
rear (1.32)
6468
Shock pivot
ball
6468
Shock rod
end
6466
Shock
downstops
x2
:: Shocks Build - Bag G-GG - Step 4
* Shock Bleeding Steps:
1. Pull shock shaft down.
2. Fill shock body 3/4 full with silicone fluid.
3. Slowly move the shock shaft up and
down to remove air from under piston.
4. Wait for bubbles to come to surface.
5. Fill shock body to top with silicone fluid.
6. Place several drops of oil in the cap and
on cap threads.
7. Install cap and tighten completely.
8. Slowly compress shaft all the way to
the top. If there is pressure at the top
of the stroke, there is too much oil.
You must bleed it out.
9. Slowly pull shaft down.
10. Unscrew the cap 3/4 turn and tilt the
shock at a slight angle.
11. Slowly compress the shaft to push out
excess oil and air. You should see
bubbles coming out from under the cap.
12. With the shaft compressed, tighten the
cap and re-check for pressure at the top
of the stroke. If there is still pressure,
repeat steps 9 thru11.
Step 7
Step 1-3
Shock fluid
30wt
#5422
Step 5-6
Shock fluid
30wt #5422
Step 3-4
6450
RC10
shock cap
6469
Shock cap
o-ring
Place on table
and push down
hard until clamp
snaps into place
!
Remove
spurs
SNAP!
SNAP!
Shock fluid
30wt #5422
Shock fluid
30wt #5422
Build x2 front and x2 rear shocks
Summary of Contents for 6001
Page 1: ......
