4335, qty 2 ea
pivot socket,
upper and lower
4334, qty 8
2-56 x 5/16
8191, qty 1
T-bar, .075"
REMOVE THESE
PARTS FOR:
8018: steps 1-3
1:1
1:1
TOOLS USED
5
step 1
T-BAR ASSEMBLY
Assemble the #4335 T-bar sockets and
#4336 pivot balls.
Secure the T-bar pivot assembly to the
#8191 T-bar using four #4334 screws as
shown, installing both on the same side of
the T-bar. The side with the screw head
showing will be the bottom.
4336, qty 2
pivot ball
LEFT SIDE
step 2
RIGHT SIDE
REAR POD ASSEMBLY
Bolt the #8461 lower pod plate to the black #4536 left bulkhead with three #6934
blue aluminum screws.
Bolt the aluminum #4537 motor bulkhead with two #7673 screws.
Attach the lower pod plate to the T-bar with two #4526 spacers, two #6292 screws,
and two #4449 locknuts. The spacer goes between the T-bar and the pod plate.
The T-bar is on top.
Be sure to use the set of mounting holes shown in the
drawing.
4536, qty 1
left rear bulkhead
4537, qty 1
motor bulkhead
8461, qty 1
lower pod plate
1:1
4526, qty 2
T-bar spacer
molded plastic
1:1
1:1
6292, qty 2
4-40 x 3/8
steel
.050", 1/16"
4335
4335
4335
4335
4334
4334
4336
8191
4336
4526
4526
6292
7673
7673
6934
4536
4537
4449
4449
8461
7260
4519
T-BAR TO CHASSIS
Insert the #4519 screw through the chassis hole shown
and into the T-bar.
Place the #8192 T-bar brace over the screw and secure
with a #7260 plain nut.
step 3
LEFT SIDE
7260, qty 1
4-40 nut
8192, qty 1
T-bar brace
8192
6934, qty 3
4-40 x 3/8
blue aluminum
6934
6934
1:1
7673, qty 2
4-40 x 5/16
steel
1:1
4519, qty 1
4-40 x 9/16
6292
BLUE ALUMINUM
1:1
1:1
4449, qty 2
4-40 locknut