6
REMOVE THESE
PARTS FOR:
8018: steps 4-6
1:1
TOOLS USED
step 4
LEFT SIDE
REAR CHASSIS BRACE ASSEMBLY
Mount the aluminum #4442 and #4515
standoffs to the #8313 rear chassis
brace with one #6270 steel ball end
and two #6919 screws where shown.
Mount the #8186 rear body mounts to
the rear chassis brace in the holes
shown and secure the mounts using
two #6917 screws.
Mount a #4448 blue aluminum ball end
with #4449 locknut where shown.
1:1
4442, qty 2
dampener brace
standoff
1:1
6919, qty 4
4-40 x 5/16
1:1
6917, qty 3
4-40 x 3/8
8186, qty 2
rear body mount
8462, qty 1
rear chassis brace
1:1
4515, qty 1
dampener center post
1/16"
1:1
4449, qty 4
4-40 locknut
8313
8186
6917
6919
6919
6270
(steel)
4442
4442
4515
6917
8186
CHASSIS BRACE/NERF BAR
MOUNTING
Align the #8312 molded nerf
bar over the rearmost chassis
holes, the large hole of the nerf
bar to the rear. Mount the bar
to the chassis with the #6292
screw through the forwardmost
hole of the bar.
Push the outside aluminum
standoff through the rear hole
of the nerf bar. Insert the
#6915 screw up through the
chassis then into the rear pivot
part of the T-bar, and screw it
into the center chassis brace
standoff tube.
Secure the outside aluminum
standoffs to the chassis with
two #7673 screws.
step 5
LEFT SIDE
6292
6915
7673
8312
7673
DAMPENER PLATE
ASSEMBLY
Install the three #4448
ball ends, two #6372
spacers and three #4449
locknuts where shown.
Be sure to use the
correct set of mounting
holes as shown!
Install the #8463
dampener plate to the
rear pod using two
#6919 screws into the
aluminum bulkhead and
the longer #6917 screw
into the plastic bulkhead.
step 6
LEFT SIDE
8316
6919
4449
4448
6917
4449
4448
6372
6919
8463, qty 1
dampener plate
8312, qty 1
molded nerf bar
1:1
6915, qty 1
4-40 x 5/8
6292, qty 1
4-40 x 3/8
1:1
7673, qty 2
4-40 x 5/16
1:1
6372, qty 2
spacer
1:1
6270, qty 1
4-40 ball end
steel
1:1
4448, qty 4
4-40 ball end
blue aluminum
4449
4448 (blue
aluminum)
4448
